Kubota M5040 Workshop Manual page 152

M5040, M6040, M7040, WSM
Steering Support Under Cover and Rear Bonnet
1. Remove the steering support under cover (1).
2. Loosen the rear bonnet mounting screws (4).
3. Remove the seal (6) and panel guide mounting screw (5).
4. Disconnect the wire harness and remove the panel guide (2) and
rear bonnet (3).
(1) Steering Support Under Cover
(2) Panel Guide
(3) Rear Bonnet
Oil Cooler Pipe and Clamp
1. Disconnect the oil cooler pipe 1 (1) and oil cooler pipe 2 (2).
(When reassembling)
Oil cooler pipe retaining
Tightening torque
nut
(1) Oil Cooler Pipe 1
Power Steering Pipe and OIl Cooler Pipe (CABIN Model)
1. Remove the power steering pipe (1).
2. Remove the oil cooler pipe (2).
3. Remove the steering joint shaft (3).
(When reassembling)
Power steering pipe
retaining nut
Tightening torque
Oil cooler pipe retaining
nut
(1) Power Steering Pipe
(2) Oil Cooler Pipe
1-S26
ENGINE
(4) Screw
(5) Screw
(6) Seal
W1057994
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
(2) Oil Cooler Pipe 2
W1058314
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
(3) Steering Joint Shaft
W1058442
KiSC issued 06, 2008 A