Kubota M5040 Workshop Manual page 225

M5040, M6040, M7040, WSM
(3) Separating Clutch Housing from Transmission Case
Removing Cabin from Body (CABIN Model)
1. Refer to "10. CABIN" section.
Removing ROPS Upper
1. Loosen the ROPS under frame (4) mounting screws. (Do not
remove screws.)
2. Remove the ROPS upper frame (1).
(When reassembling)
• To assemble the ROPS, fix the upper frame with screw (2) and
pin (3) temporarily, then tighten the under frame screws evenly
with specified torque.
• Attach the upper frame with screws (2) so not to fall down.
ROPS under frame
Tightening torque
mounting screw (M16, 9T)
ROPS upper frame lift
up force at center of Reference value
upper frame
(1) ROPS Upper Frame
(2) Screw
Lift Rod, Lower Link and Fender (R.H., L.H.)
1. Place the disassembling stand under the transmission case.
2. Remove the lift rod (3) and lower link (4).
3. Remove the rear wheel (2) (R.H., L.H.).
4. Disconnect the wire harness from turn signal light and PTO
switch.
5. Disconnect the PTO clutch cable (5).
6. Remove the rear fender (1) (R.H., L.H.).
(When reassembling)
Tightening torque Rear wheel mounting nut
(1) Fender
(2) Rear Wheel
(3) Lift Rod
ROPS Under, Fuel Tank and Seat
1. Disconnect the wire harness from seat and remove the seat (1).
2. Disconnect the wire harness from fuel level sensor (4).
3. Remove the fuel tank (3).
4. Remove the ROPS under frame (R.H., L.H.).
(When reassembling)
ROPS under frame
Tightening torque
mounting screw (M16, 9T)
(1) Seat
(2) ROPS Under Frame
2-S19
CLUTCH
W1044097
259.9 to 304.0 N·m
26.5 to 31.0 kgf·m
191.7 to 224.2 lbf·ft
245.2 to 284.2 N
25.0 to 29.0 kgf
55.1 to 63.9 lbf
(3) Pin
(4) ROPS Under Frame
W1041135
260 to 304 N·m
26.5 to 31.0 kgf·m
191.8 to 224.2 lbf·ft
(4) Lower Link
(5) PTO Clutch Cable
W1044376
259.9 to 304.0 N·m
26.5 to 31.0 kgf·m
191.7 to 224.2 lbf·ft
(3) Fuel Tank
(4) Fuel Level Sensor
W1044655
KiSC issued 06, 2008 A