Kubota M5040 Workshop Manual page 52

M5040, M6040, M7040, WSM
Cleaning Air Filter (CABIN Model)
Fresh Air Filter
1. Remove the knob bolts (3) and pull out the fresh air filter (1).
2. Blow air from the opposite direction to the filter's normal air flow.
NOTE
• If the filter is very dirty :
Dip the filter in lukewarm water with mild dish washing
detergent.
Move it up and down as well as left and right to loosen dirt.
Rinse the filter with clean water and let it air-dry.
IMPORTANT
• Do not use gasoline, thinner or similar chemicals to clean
the filter as damage to the filter may occur.
• If may also cause an unpleasant odor in the cabin when the
system is used next.
• Do not hit the filter. If the filter becomes deformed, dust may
enter into the air-conditioner, which may cause damage and
malfunction.
(1) Fresh Air Filter
(2) Cover
(3) Knob Bolt
Checking Air Conditioner Condenser (CABIN Model)
1. Release the air conditioner hoses off the hook (1).
2. Loosen the wing nut (2).
3. Hold the handle (3), slide out the air conditioner condenser
assembly (6).
4. Check air conditioner condenser to be sure it is clean of debris.
CAUTION
• Be sure to stop the engine before removing the screen.
• The condenser and receiver become hot while the air
conditioner is running. Before checking or cleaning them,
wait long enough until they cool down.
IMPORTANT
• Do not hold the air conditioner receiver or the air conditioner
pipes when sliding out the condenser for cleaning.
(1) Hook
(2) Wing Nut
(3) Handle
G-30
G GENERAL
a : Air Inlet Port
b : Air Conditioner Air Flow
W1019336
(4) Receiver
(5) Air Condenser Hose
(6) Condenser
W1019699
KiSC issued 06, 2008 A