M5040, M6040, M7040, WSM
Preparation 2
Without discharging the refrigerant from system
1. Remove the air conditioner belt (2).
2. Remove the compressor (3) and condenser (4) without removing
the air conditioner hoses.
3. Disconnect the heater hoses (1).
(When reassembling)
• Take care not to damage the air condenser fin.
• After reassembling the compressor, be sure to adjust the air
condenser belt tension.
MAINTENANCE" at "G. GENERAL" section.)
(1) Heater Hose
(2) Belt
Preparation 3
1. Remove the steering joint shaft (1).
2. Remove the hose clamp (2).
3. Disconnect the accelerator wire (3).
(When reassembling)
• Be sure to fix the heater hose to the original position. Note the
inlet hose and outlet hoses.
Power steering joint shaft
Tightening torque
mounting screw
(1) Power Steering Joint Shaft
(2) Hose Clamp
10-S34
(Refer to "7. CHECK
(3) Compressor
(4) Condenser
W1029723
23.6 to 27.4 N·m
2.4 to 2.8 kgf·m
17.4 to 20.2 lbf·ft
(3) Accelerator Wire
W1052713
CABIN
AND
KiSC issued 06, 2008 A