Check Points Of Every 300 Hours; Checking Intake Air Line; Adjusting Toe-In - Kubota B2410 Workshop Manual

G GENERAL
82410 • 82710 • 82910 WSM, 12271
Checking Intake Air Line
1. Check to see that hoses and hose clamps are tight and not
damaged.
2. If hoses and clamps are found worn or damaged, replace or
repair them at once.
(1) Hose (2) Hose Clamps
12270G00460
11790F60020
12270F00240
(A)
t
(C)
(B)
~I
Adjusting Toe-in
1. Park the tractor on the flat place.
2. Inflate the tires to the specified pressure.
3. Turn steering wheel so front wheels are in the straight ahead
position.
4. Lower the implement, lock the parking brake and stop the
engine.
5. Measure distance between tire beads at frontof tire, hub height.
6. Measure distance between tire beads at rear of tire, hub height.
7. Front distance should be 0 to 7 or 10 mm (0 to 0.28 or 0.39 in.)
less than rear distance.
8. If the measurement is not within the factory specifications, adjust
by changing the tie rod length.
82410
o
to 10 mm
Factory
o
to 0.39 in.
Toe-in (8 - A)
spec.
82710
o
to 7 mm
82910
o
to 0.28 in.
• Adjusting
1. Loosen the lock nuts and turn the tie rod to adjust the rod length
until the proper toe-in measurement is obtained.
2. Retighten the lock nuts.
(6) Check Points of Every 300 Hours
(1) Lock Nut
(2) Tie Rod
Changing Transmission Fluid
1. See page G-13.
(A) Wheel to Wheel Distance at front
(8) Wheel to Wheel Distance at rear
(C) Front
12271 G00130
12270G00390
Cleaning Transmission Oil Strainer
1. See page G-14.
12270G00240
Replacing Hydraulic Oil Filter Cartridge
1. See page G-14.
12490G00230
G-24