Kubota M5040 Workshop Manual page 286

M5040, M6040, M7040, WSM
Input Shaft and Shuttle Shaft
1. Remove the bearing (1) and external circlip (2) from input shaft
(15).
2. Draw out the 27T gear (4) to forward.
3. Remove the external circlip (12) and draw out the coupling (14).
4. Remove the external circlip (19) and bearing (8).
5. Draw out the 29T gear (16) to rearward.
NOTE
• Four discs and five plates for one side.
(When reassembling)
• Replace the external circlips with new one.
• Apply enough transmission fluid to the discs (11).
• Check the clearance between holder 2 and coupling both forward
and reverse side with a feeler gauge.
If the Clarence is exceeds the factory specifications, adjust it
(refer to "6. SERVICING" in this section).
(1) Bearing
(2) External Circlip
(3) Bearing
(4) 27T Gear
(5) Bearing
(6) Holder 1
(7) Spacer
(8) Steel Plate
(9) Disc
(10) Holder 2
3-S33
TRANSMISSION
(11) Spring
(12) External Circlip
(13) Key
(14) Coupling
(15) Input Shaft
(16) 29T Gear
(17) Bearing
(18) Bearing
(19) External Circlip
W1016016
KiSC issued 06, 2008 A