Kubota M5040 Workshop Manual page 417

M5040, M6040, M7040, WSM
Position Feedback Rod and Draft Feedback Rod
1. Tap out the roll pin (4), remove the position feedback rod (1) with
position feedback lever (3).
2. Remove the draft feedback rod (2) with draft feedback lever (5).
(When reassembling)
• Adjust the position and feedback rod length to the factory
specifications.
Position feedback rod
Factory spec.
length
Draft feedback rod
Factory spec.
length
(1) Position Feedback Rod
(2) Draft Feedback Rod
(3) Position Feedback Lever
Control Valve and Spool Lever
1. Remove the control valve mounting screws.
2. Remove the E-shaped stopper (3).
3. Take out the control valve (1) and spool lever (2).
(When reassembling)
• Be sure to fix the O-rings to the control valve and apply grease to
them.
NOTE
• Do not disassemble the spool joint 1 (4) from the spool (5)
unless necessary.
If disassembled due to unavoidable reasons, record the
installation length (L) of the spool joint 3 (6) and spool (5).
When reassembling, be sure to make to a former length.
Control valve mounting
Tightening torque
screw
Length (L) Reference value
(1) Control Valve
(2) Spool Lever
(3) E-shaped Stopper
8-S19
HYDRAULIC SYSTEM
156 mm
6.14 in.
252 mm
9.92 in.
(4) Roll Pin
(5) Draft Feedback Lever
W1021825
19.6 to 23.5 N·m
2.0 to 2.4 kgf·m
14.5 to 17.4 lbf·ft
24.5 to 25.0 mm
0.9646 to 0.9842 in.
(4) Spool Joint 1
(5) Spool
(6) Spool Joint 3
W1023394
KiSC issued 06, 2008 A