Kubota M5040 Workshop Manual page 270

M5040, M6040, M7040, WSM
Oil Cooler Pipe
1. Remove the oil cooler pipes (1) and (2).
2. Disconnect the power steering hoses (3).
(When reassembling)
Oil cooler pipe retaining
nut
Tightening torque
Power steering hose
retaining nut
(1) Oil Cooler Pipe
(2) Oil Cooler Pipe
Separating Engine from Clutch Housing
1. Make sure the engine and clutch housing case are securely
mounted on the disassembling stands.
2. Install the front axle rocking restrictor (1) (refer to "8. SPECIAL
TOOLS" at "G. GENERAL" section) to the front axle bracket.
3. Remove the engine mounting screws and nut, and separate the
engine from the clutch housing.
(When reassembling)
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to the splines of damper disc boss.
• Apply liquid gasket (Three Bond 1141, 1211 or equivalent) to joint
face of the engine and clutch housing.
Engine and clutch housing
mounting screw and nut
(M14, 7T)
Tightening torque
Engine and clutch housing
mounting stud bolt
(1) Front Axle Rocking Restrictor
3-S17
TRANSMISSION
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
22.6 to 27.5 N·m
2.3 to 2.8 kgf·m
16.6 to 20.3 lbf·ft
(3) Power Steering Hose
W1013245
124 to 147 N·m
12.6 to 15.0 kgf·m
91.2 to 108 lbf·ft
61.8 to 73.6 N·m
6.3 to 7.5 kgf·m
45.6 to 54.2 lbf·ft
W1013389
KiSC issued 06, 2008 A