M5040, M6040, M7040, WSM
Clutch Case
1. Remove the external circlip (7).
2. Remove the clutch case (5), brake disc (3) and brake plate (2).
(When reassembling)
• Direct the contact part of the brake disc (3) to the brake plate (2).
• Apply small amount of grease to the seal rings (8).
(1) Clutch Case
(2) Brake Plate
(3) Brake Disc
(4) Needle Bearing
Piston
1. Press the washer (4) lightly by the hand press, using the
hydraulic clutch spring compressor.
TOOLS" at "G. GENERAL" section.)
2. Remove the external circlip (3).
3. Draw out the piston (6).
(When reassembling)
• Apply enough transmission fluid to seal ring (7) and (8).
(1) Clutch Case
(2) Jig
(3) External Circlip
(4) Washer
2-S26
CLUTCH
(5) Clutch Holder
(6) Bearing
(7) External Circlip
(8) Seal Ring
W1024435
(Refer to "8. SPECIAL
(5) Spring
(6) Piston
(7) Seal Ring
(8) Seal Ring
W1024734
KiSC issued 06, 2008 A