Kubota M5040 Workshop Manual page 293

M5040, M6040, M7040, WSM
DT Gear and Shaft
1. Tap out the roll pin (3) and remove the DT shift lever (4).
2. Remove the DT shift arm (6) retaining plate (2).
3. Pull the DT shift arm (6) to outside.
4. Remove the oil seal (1) and internal circlip (7).
5. Tap out the DT shaft (8) to forward.
(When reassembling)
• Be sure to insert the DT shift arm (6) groove of shifter (5) as
shown photo.
• Replace the oil seal (1) with new one.
(1) Oil Seal
(2) Retaining Plate
(3) Roll Pin
(4) DT Shift Lever
(5) Shifter
(6) Shift Arm
3-S40
TRANSMISSION
(7) Internal Circlip
(8) DT Shaft
(9) 32T Gear
(10) Thrust Collar
(11) Bearing
W1024417
KiSC issued 06, 2008 A