Kubota M5040 Workshop Manual page 413

M5040, M6040, M7040, WSM
Removing 3-point Hitch Hydraulic Block Assembly
1. Remove the 3-point hitch hydraulic block mounting screws and
nuts.
2. Remove the 3-point hitch hydraulic block assembly with nylon lift
strap and hoist.
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of transmission case and cylinder block.
NOTE
• After reassembling the cylinder block assembly to the
tractor, be sure to adjust the position and draft feedback
rods.
3-point hitch hydraulic
block mounting screw
Tightening torque
3-point hitch hydraulic
block mounting nut
8-S15
HYDRAULIC SYSTEM
166.7 to 196.1 N·m
17.0 to 20.0 kgf·m
123.0 to 144.7 lbf·ft
123.6 to 147.1 N·m
12.6 to 15.0 kgf·m
91.1 to 108.5 lbf·ft
W1020724
KiSC issued 06, 2008 A