Kubota M5040 Workshop Manual page 62

M5040, M6040, M7040, WSM
Replacing Light Bulb
CAUTION
• Be careful not to drop the bulb, hit anything against the
lamp, apply excess force, and get the lamp scratched. If
broken, glass may cause injury.
halogen lamps in particular, which have high pressure
inside.
• Before replacing the lamp, be sure to turn off the light and
wait until the bulb cools down, otherwise, you may get
burned.
Head lights
1. While pushing the right and left lock buttons (2), pull and remove
the electrical connector (1).
2. Remove the rubber boot (3).
3. Remove the clamping fixture (4) and take out the bulb (5).
4. Replace with a new bulb and reinstall the head lamp assembly in
the reverse order.
Other lights
1. Detach the lens and replace the bulb.
IMPORTANT
• Be sure to use a new bulb of the specified wattage.
• Never touch the bulb surface (glass) with bare hands.
Fingerprints, for example, may break the bulb.
Light
Head lights
Hazard lights
Turn signal
Tail light
Work light (if equipped)
Front work light
Work light
(for outer roof)
Dome light (Room lamp)
(1) Electrical Connector
(2) Lock Button
(3) Rubber Boot
Lubricating Points (CABIN Model)
(1) Door Hinge
G-40
Pay more attention to
Capacity
12V, 55 / 60 W (H4)
12V, 23 W
12V, 21 W
12 V, 5 W
12 V, 35 W Option for ROPS Model
12 V, 21 W
12 V, 55 W CABIN Model
12 V, 5 W CABIN Model
(4) Clamping Fixture
(5) Bulb
(2) Rear Window Hinge
G GENERAL
Remark
W1080544
W1120093
KiSC issued 06, 2008 A