Kubota M5040 Workshop Manual page 92

M5040, M6040, M7040, WSM
Bevel Gear Shaft Tool
Application : Use for measuring and tightening the bevel gear shaft.
Bevel gear for front axle
12.75 to 12.90 mm square
A
(0.50 to 0.51 in. square)
B 25 mm dia. (0.984 in. dia.)
C 22.5 mm dia. (0.886 in. dia.)
D 0.52 rad (30 °)
E 26.0 mm dia. (1.02 in. dia.)
F Involute spline (refer to below)
G Chamfer 1.0 mm (0.039 in.)
H 30 mm (1.18 in.)
I 5 mm (0.19 in.)
J 55 mm (2.17 in.)
K 30 mm dia. (1.18 in. dia.)
L 40 mm dia. (1.57 in. dia.)
(Involute Spline)
Spline (Internal)
Coefficient of profile shifting
Tooth form
Tool Module
Pressure angle
Number of teeth
Diameter of basic pitch
circle
Grade
Tooth
Between pin
thickness
diameter
(Reference)
• This tool can be made by welding the coupling (33710-04130)
and socket wrench for front bevel gear shaft.
• This tool can be made by welding the coupling (3C001-32010)
and socket wrench for rear bevel gear shaft.
G-70
Bevel gear for rear axle
12.75 to 12.90 mm square
(0.50 to 0.51 in. square)
30.000 to 30.025 mm dia.
(1.1811 to 1.1821 in. dia.)
32.5 mm dia. (1.28 in. dia.)
0.52 rad (30 °)
32.6 to 33.0 mm dia.
(1.28 to 1.29 in. dia.)
Involute spline (refer to below)
Chamfer 1.0 mm (0.039 in.)
30 mm (1.18 in.)
5 mm (0.19 in.)
55 mm (2.17 in.)
40 mm dia. (1.57 in. dia.)
50 mm dia. (1.97 in. dia.)
Bevel gear for front axle Bevel gear for rear axle
25 x 18Z x 1.25m x 20 32.5 x 24Z x 1.25m x 20
+0.800 +0.800
Stub tooth Stub tooth
1.250 1.250
0.35 rad (20 °) 0.35 rad (20 °)
18 24
22.5 mm 30.0 mm
Class a Class a
20.084 to 20.155 mm 27.584 to 27.656 mm
(Pin diameter = 2.50 (Pin diameter = 2.50
mm) mm)
G GENERAL
W1015236
KiSC issued 06, 2008 A