Kubota M5040 Workshop Manual page 218

M5040, M6040, M7040, WSM
Accelerator Wire, Fuel Hose and Wire Harness
1. Disconnect the accelerator wire (4) and fuel hose (2).
2. Disconnect the wire harness from water temperature sensor (3),
engine speed sensor (5) and glow plug (1).
3. Disconnect the fuel hose (9) from fuel filter.
4. Disconnect the 2P connector (10) from alternator (11) and wire
harness from alternator B terminal (6).
5. Disconnect the wire harness from the engine oil pressure switch
(8).
6. Disconnect the 3P connector (7) from engine stop solenoid.
(1) Glow Plug
(2) Fuel Hose
(3) Water Temperature Sensor
(4) Accelerator Wire
(5) Engine Speed Sensor
(6) Alternator B Terminal
Oil Cooler Pipe and Clamp
1. Disconnect the oil cooler pipe (1).
2. Remove the pipe clamp (2).
(When reassembling)
Oil cooler pipe retaining
Tightening torque
nut
(1) Oil Cooler Pipe
Steering Support Under Cover and Rear Bonnet
1. Remove the steering support under cover (1).
2. Loosen the rear bonnet mounting screws (4).
3. Remove the seal (6) and panel guide mounting screw (5).
4. Disconnect the wire harness and remove the panel guide (2) and
rear bonnet (3).
(1) Steering Support Under Cover
(2) Panel Guide
(3) Rear Bonnet
2-S12
CLUTCH
(7) 3P Connector
(8) Engine Oil Pressure Switch
(9) Fuel Hose
(10) 2P Connector
(11) Alternator
W1040397
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
(2) Clamp
W1040843
(4) Screw
(5) Screw
(6) Seal
W1041042
KiSC issued 06, 2008 A