Kubota M5040 Workshop Manual page 545

M5040, M6040, M7040, WSM
Preparation 6
1. Place the disassembling stand under the transmission case and
drawbar bracket.
2. Remove the rear wheels (R.H., L.H.).
3. Remove the fuel tank (1).
4. Disconnect the shuttle cable (2) and clutch cable (3).
5. Disconnect the PTO clutch cable (4).
6. Disconnect the auxiliary control wire (6).
7. Disconnect the lowering speed adjusting rod (5).
8. Disconnect the ground cable (7).
(When reassembling)
• Be sure to adjust the PTO clutch lever movement by the PTO
clutch cable (4). (Refer to "4. CHECKING AND ADJUSTING" at
"2. CLUTCH" section.)
Tightening torque Rear wheel mounting nut
(1) Fuel Tank
(2) Shuttle Cable
(3) Clutch Cable
(4) PTO Clutch Cable
10-S37
260 to 304 N·m
26.5 to 31.0 kgf·m
191.8 to 224.2 lbf·ft
(5) Lowering Speed Adjusting Rod
(6) Auxiliary Control Wire
(7) Ground Cable
W1031848
KiSC issued 06, 2008 A
CABIN