Kubota M5040 Workshop Manual page 228

M5040, M6040, M7040, WSM
(4) Removing PTO Clutch Valve
Draining Fuel
1. Refer to "7. CHECK
LUBRICANTS, FUEL AND COOLANT" at "G. GENERAL"
section.
Rear Wheel (L.H.) and Fender (L.H.)
1. Place the disassembling stand under the transmission case.
2. Remove the rear wheel (2) (L.H.).
3. Remove the fender (1) (L.H.).
(When reassembling)
Tightening torque Rear wheel mounting nut
(1) Fender
Fuel Tank
1. Disconnect the wire harness from fuel level sensor (2).
2. Remove the fuel tank (1).
(1) Fuel Tank
PTO Clutch Valve
1. Disconnect the PTO clutch wire (1) from PTO clutch valve (3).
2. Remove the PTO delivery pipe (2) from PTO clutch valve (3).
3. Remove the PTO clutch valve assembly (3).
(When reassembling)
• Replace the PTO pipe (4) with new ones and apply oil to them.
• When assembling the PTO clutch valve, adjust the PTO wire.
(Refer to "4. CHECKING AND ADJUSTING" in this section.)
PTO delivery pipe joint
Tightening torque
screw
(1) PTO Clutch Wire
(2) PTO Delivery Pipe
2-S22
AND MAINTENANCE" and "4.
260 to 304 N·m
26.5 to 31.0 kgf·m
191.8 to 224.2 lbf·ft
(2) Rear Wheel
(2) Fuel Level Sensor
29.4 to 34.3 N·m
3.0 to 3.5 kgf·m
21.7 to 25.3 lbf·ft
(3) PTO Clutch Valve
(4) Hydraulic Pipe
CLUTCH
W1046689
W1046760
W1047207
W1047337
KiSC issued 06, 2008 A