Kubota M5040 Workshop Manual page 229

M5040, M6040, M7040, WSM
[2] DAMPER DISC (HYDRAULIC SHUTTLE MODEL)
[3] CLUTCH DISC (SYNCHRO SHUTTLE MODEL)
Removing Damper Disc
1. Remove the damper disc (1).
(When reassembling)
• Direct the shorter end of the damper disc boss toward the
flywheel.
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to the spline.
Damper disc mounting
Tightening torque
screw
(1) Damper Disc
Removing Clutch
1. Remove the clutch from the flywheel.
(When reassembling)
• Direct the shorter end of the clutch disc boss toward the flywheel.
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to the splines of clutch disc boss.
• Install the pressure plate, noting the position of straight pins.
IMPORTANT
• Align the center of disc and flywheel by inserting the clutch
center tool.
NOTE
• Do not allow grease and oil on the clutch disc facing.
Tightening torque Clutch mounting screw
Release Holder and Clutch Lever
1. Draw out the clutch release holder (2) and the release bearing (1)
as a unit.
2. Remove the release fork setting screws (5).
3. Draw out the clutch lever (4) to remove the release fork (3).
(When reassembling)
• Make sure the direction of the release fork (3) is correct.
• Inject grease to the release holder (2).
• Apply grease to the bushing and clutch lever.
• After tightening the release fork setting screw to the specified
torque, insert a wire through the hole on the setting screw head
and bind with release fork together.
Tightening torque Release fork setting screw
(1) Release Bearing
(2) Release Holder
(3) Release Fork
2-S23
CLUTCH
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 lbf·ft
W1030546
23.5 to 27.5 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 lbf·ft
W1047775
166.7 to 191.2 N·m
17.0 to 19.5 kgf·m
123.0 to 141.1 lbf·ft
(4) Clutch Lever
(5) Setting Screw
W1047965
KiSC issued 06, 2008 A