Kubota M5040 Workshop Manual page 363

M5040, M6040, M7040, WSM
Bevel Gear Case and Front Wheel Case Bushing
1. Visually inspect the DX bushings for signs of wear or damage.
(The DX bushing tends to show concentrated wear.)
2. If the DX bushing is worn beyond the alloy portion (L), replace it.
Front wheel case
Alloy thickness (L)
bushing
Bevel gear case O.D. Factory spec.
Backlash of Bevel Gear in Bevel Gear Case
1. Set a dial indicator (lever type) on the shaft (Kingpin).
2. Move the shaft (Kingpin) by hand and measure the
circumferential play of the shaft.
3. Calculate the backlash from the ratio of the shaft diameter to the
gear diameter. (Backlash = Play x 2)
4. If the backlash exceeds the allowable limit, adjust with the shims
(1).
Factory spec.
Backlash of bevel gear
in bevel gear case
Allowable limit
(Reference)
• Thickness of adjusting shims (1) :
0.1 mm (0.004 in.) [Code No.: 35533-44081]
0.4 mm (0.016 in.) [Code No.: 3A021-44021]
0.6 mm (0.024 in.) [Code No.: 3A021-44031]
0.8 mm (0.032 in.) [Code No.: 3A021-44041]
1.0 mm (0.039 in.) [Code No.: 3A021-44051]
1.2 mm (0.047 in.) [Code No.: 3A021-44061]
• Thickness of adjusting shims (2) :
0.1 mm (0.004 in.) [Code No.: 35533-43011]
0.2 mm (0.008 in.) [Code No.: 35533-43021]
0.4 mm (0.016 in.) [Code No.: 35533-43031]
(1) Shim
6-S26
FRONT AXLE
0.57 mm
0.0224 in.
54.97 to 55.00 mm
2.1642 to 2.1653 in.
W1020555
0.20 to 0.30 mm
0.0079 to 0.0118 in.
0.4 mm
0.016 in.
(2) Shim
W1020677
KiSC issued 06, 2008 A