Kubota M5040 Workshop Manual page 89

M5040, M6040, M7040, WSM
Adaptor for Sliding Hammer
Application : Use to removing the front axle bevel pinion shaft and
hydraulic pump drive gear pin with sliding hammer.
Front axle bevel pinion shaft
A M6 x P1.0
B 25 mm (0.98 in.)
C 50 mm (1.97 in.)
D 23 mm (0.91 in.)
E 27 mm (1.06 in.)
F M14 x P1.5
(1) Adaptor (M6)
LSD Adaptor
Application : Use for measuring the turning torque of LSD.
A 24.65 to 24.80 mm dia. (0.970 to 0.976 in. dia.)
B 131.85 to 132.15 mm (5.19 to 5.20 in.)
C 99.25 to 100.75 mm (3.91 to 3.97 in.)
D 54 to 60 mm full spline (2.12 to 2.36 in. full spline)
E 22.4 to 28.4 mm (0.88 to 1.11 in.)
F 4 to 6 mm (0.16 to 0.23 in.)
G 0.52 rad (30 °)
H Involute spline (refer to below)
I Chamfer 3.0 mm (0.12 in.)
J 1.05 rad (60 °)
K 29.5 to 30.5 mm dia. (1.16 to 1.20 in. dia.)
L 17.87 mm dia. (0.7 in. dia.)
M 13.95 to 14.25 mm dia. (0.55 to 0.56 in. dia.)
N 12.75 to 12.90 mm square (0.50 to 0.51 in. square)
(Involute Spline)
• EXTERNAL 25 x 24Z x 1.0 m x 30
Coefficient of profile shifting
Tooth form
Tool Module
Pressure angle
Number of teeth
Diameter of basic pitch circle
Grade
Tooth thickness
Over pitch diameter
(Reference)
• This tool can be made by welding the yoke shaft R.H. (3C091-
43210) and socket wrench.
G-67
G GENERAL
Hydraulic pump drive gear pin
M8 x P1.25
(2) Stud Bolt (M6 x P1.0)
Stud Bolt (M8 x P1.25)
W10124150
0.000
Stub tooth
1.00
0.52 rad (30 °)
24
24 mm
Class a
26.534 to 26.645 mm
(Pin diameter = 1.8 mm)
W1088756
KiSC issued 06, 2008 A