Kubota M5040 Workshop Manual page 224

M5040, M6040, M7040, WSM
Separating Engine from Clutch Housing
1. Check the engine and clutch housing case are securely mounted
on the disassembling stands.
2. Install the front axle rocking restrictor (1) (refer to "8. SPECIAL
TOOLS" at "G. GENERAL" section) to the front axle bracket.
3. Remove the floor cover and duct retainer (2).
4. Remove the seat under cover (4) and duct (3).
5. Remove the engine mounting screws and nuts.
6. Separate the engine from the clutch housing.
(When reassembling)
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to the splines of damper disc boss.
• Apply liquid gasket (Three Bond 1141, 1211 or equivalent) to joint
face of the engine and clutch housing.
Engine and clutch housing
Tightening torque mounting screw and nut
(M14, 7T)
(1) Front Axle Rocking Restrictor
(2) Duct Retainer
2-S18
CLUTCH
124 to 147 N·m
12.6 to 15.0 kgf·m
91.2 to 108 lbf·ft
(3) Duct
(4) Seat Under Cover
W1101378
KiSC issued 06, 2008 A