Disassembling Front Axle [4Wd Model] - Kubota M5040 Workshop Manual

M5040, M6040, M7040, WSM

(2) Disassembling Front Axle [4WD Model]

Tie-rod
1. Pull out the cotter pin and remove the tie-rod end slotted nuts.
2. Remove the tie-rod with a tie-rod end lifter (Code No. 07909-
39051).
(When reassembling)
• Replace cotter pin with a new one.
• Bend the cotter pin as shown in the figure.
Tie-rod end slotted nut
Tightening torque
Tie-rod joint lock nut
Separating of Front Differential Case from Bevel Gear Case
1. Remove the bevel gear case (2) and the front wheel case (3) as
a unit from the front differential case (1).
(When reassembling)
• Apply grease to the O-ring.
• Install the bevel gear case to the front differential case, noting the
O-ring.
Bevel gear case mounting
Tightening torque
screw (M16, 9T)
(1) Front Differential Case
(2) Bevel Gear Case
Bevel Gear Case
1. Remove the internal circlip (3) and shim (2) then draw out the 11T
bevel gear (1) with bearing.
2. Remove the front wheel case support (8).
3. Draw out the bevel gear shaft (5).
(When reassembling)
• Apply grease to the front wheel case support DX bushing and
front wheel case DX bushing.
• Install the oil seal to the front wheel case support so that its lip
faces the outward.
• Apply gear oil to the bearing.
Front wheel case support
Tightening torque mounting screw
(M16, 9T)
(1) 11T Bevel Gear
(2) Shim
(3) Internal Circlip
(4) Front Wheel Case
(5) Bevel Gear Shaft
6-S12
FRONT AXLE
156.9 to 176.5 N·m
16.0 to 18.0 kgf·m
115.7 to 130.2 lbf·ft
166.7 to 196.1 N·m
17.0 to 20.0 kgf·m
123.0 to 144.7 lbf·ft
W1015246
259.9 to 304.0 N·m
26.5 to 31.0 kgf·m
191.7 to 224.2 lbf·ft
(3) Front Wheel Case
W1015400
259.9 to 304.0 N·m
26.5 to 31.0 kgf·m
191.7 to 224.2 lbf·ft
(6) Bevel Gear Case
(7) Collar
(8) Front Wheel Case Support
(9) Thrust Ball Bearing
W1015548
KiSC issued 06, 2008 A