Kubota M5040 Workshop Manual page 149

M5040, M6040, M7040, WSM
Propeller Shaft (4WD Model)
1. Slide the propeller shaft cover (3) after removing the screw (8).
2. Tap out the roll pins (2) and then slide the coupling (1) to the rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft (5) and pinion
shaft.
• Tap in the roll pins (2) as shown in figure.
(1) Coupling
(2) Roll Pin
(3) Propeller Shaft Cover
(4) Roll Pin
Power Steering Hose
1. Disconnect both power steering hoses (2) from power steering
cylinder (1).
(When reassembling)
• Connect the power steering hose with blue tape (3) to the R.H..
Power steering hose
Tightening torque
retaining nut
(1) Power Steering Cylinder
(2) Power Steering Hose
Radiator Hose and Oil Cooler Pipe
1. Disconnect the radiator hoses (1) and (3).
2. Disconnect the oil cooler pipe retaining nuts (2).
3. Remove the power steering hose clamp (4).
(When reassembling)
Oil cooler pipe retaining
Tightening torque
nut
(1) Radiator Hose
(2) Oil Cooler Pipe Retaining Nut
1-S23
ENGINE
(5) Propeller Shaft
(6) Cover
(7) Coupling
(8) Screw
W1054851
22.6 to 27.5 N·m
2.3 to 2.8 kgf·m
16.6 to 20.3 lbf·ft
(3) Blue Tape
W1055187
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
(3) Radiator Hose
(4) Clamp
W1055318
KiSC issued 06, 2008 A