Kubota M5040 Workshop Manual page 491

M5040, M6040, M7040, WSM
Pulley
1. Hold the rotor (base of the claw) in a vise. Loosen the lock nut
using a M24 box wrench.
Tightening torque Pulley nut
Rotor
1. Remove the 4 screws and detach the bearing retainer.
2. Temporarily install the nut on the pulley screw, and detach the
rotor.
Brush
1. When the rotor is detached, the 2 brushes are found to stretch
out of the shaft hole.
9-S40
ELECTRICAL SYSTEM
58.3 to 78.9 N·m
5.95 to 8.05 kgf·m
43.0 to 58.2 lbf·ft
W1018613
W1018685
W1018748
KiSC issued 06, 2008 A