Kubota M5040 Workshop Manual page 425

M5040, M6040, M7040, WSM
Torsion Bar and Top Link Bracket
1. Visually inspect the DX bushings for signs of wear or damage.
(The DX bushing tends to show concentrated wear.)
2. If the DX bushing is worn beyond the alloy portion (A), replace it.
(When installing)
• When press-fitting a new bushing, apply transmission fluid to the
bushing press in position.
• When press-fitting a new bushing of top link bracket, the seam of
bushing face to rear.
• When press-fitting a new bushing of torsion bar, the hole of
bushing face lower to align with grease gallery.
(Reference)
Lift arm bushing Alloy thickness (A)
A : Alloy Thickness
8-S27
HYDRAULIC SYSTEM
0.57 mm
0.0224 in.
W1026668
KiSC issued 06, 2008 A