Kubota M5040 Workshop Manual page 302

M5040, M6040, M7040, WSM
Clearance between Holder 2 and Coupling
1. Measure the clearance (L) between holder 2 and coupling with a
feeler gauge.
2. If the clearance (L) exceeds the factory specification, adjust the
clearance using different thickness of steel plate.
3. Remeasure to confirm the correct clearance (L).
NOTE
• Clearance between holder 2 and coupling is adjusted by two
kinds of steel plates with different thickness. Therefore, use
the one of the same thickness when you change steel plates.
Clearance (L) between
holder 2 and coupling Factory spec.
(F and R side)
(Reference)
• There are two kinds of thickness steel plates.
• Thickness of clutch disc and steel plate.
Clutch disc Factory spec.
Steel plate
Factory spec.
(3C081-23490)
Steel plate
Factory spec.
(3C081-23571)
(a) Plate Thickness I.D. for 1.4 mm
(0.055 in.)
3-S49
TRANSMISSION
1.8 to 2.0 mm
0.071 to 0.079 in.
1.57 to 1.73 mm
0.0618 to 0.0681 in.
1.2 mm
0.047 in.
1.4 mm
0.055 in.
L : Clearance
W1024703
KiSC issued 06, 2008 A