Kubota M5040 Workshop Manual page 289

M5040, M6040, M7040, WSM
37T Gear and 35T Gear
1. Remove the external circlip (1) and 37T gear (2).
2. Remove the external circlip (4) and 35T gear (3).
(When reassembling)
• Check the clearance (L) between external circlip (1) and
adjusting collar (5).
• If the measurement is not within the factory specification, adjust
with shim.
(Reference)
• Thickness of adjusting collar (5).
3.00 mm (0.118 in.)
3.2 mm (0.126 in.)
3.4 mm (0.134 in.)
3.6 mm (0.142 in.)
Clearance (L) Factory spec.
(1) External Circlip
(2) 37T Gear
(3) 35T Gear
3-S36
TRANSMISSION
Less than 0.2 mm
0.0078 in.
(4) External Circlip
(5) Adjusting Collar
L : Clearance
W1021436
KiSC issued 06, 2008 A