Kubota M5040 Workshop Manual page 350

M5040, M6040, M7040, WSM
Front Wheel Case Cover
1. Remove the front wheel case cover (1) from the front wheel case
(4).
(When reassembling)
• Apply transmission fluid to the O-ring.
• Install the shim (3) to its original position.
Front wheel case cover
Tightening torque
mounting screw
(Reference)
• Thickness of shim (3) :
0.4 mm (0.0158 in.)
0.6 mm (0.0237 in.)
0.8 mm (0.0315 in.)
1.0 mm (0.0394 in.)
1.2 mm (0.0473 in.)
(1) Front Wheel Case Cover
(2) O-ring
Front Wheel Case
1. Remove the cap (10) which is installed in the bottom of front
wheel case.
2. Remove the internal circlip (9) and take out the adjusting shims
(8).
3. Tap the bevel gear to downward, and take out the 10T bevel gear
(6) with bearing.
(When reassembling)
• Apply grease to the front wheel case DX bushing (2).
• Apply grease to the oil seal.
• Replace the cap (10) with new one.
• Apply transmission fluid to the cap.
(1) Oil Seal
(2) DX Bushing
(3) Thrust Ball Bearing
(4) Front Wheel Case
(5) Plug
(6) 10T Bevel Gear
Bevel Gear
1. Remove the bevel gear and bearing with a puller.
(1) Bevel Gear
6-S13
FRONT AXLE
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 lbf·ft
(3) Shim
(4) Front Wheel Case
W1016102
(7) Ball Bearing
(8) Shim
(9) Internal Circlip
(10) Cap
(11) Plug
W1016239
W1016676
KiSC issued 06, 2008 A