Gestetner B070 Service Manual page 1154

BULLETIN NUMBER:
APPLICABLE MODEL:
GESTETNER – 9002/10512
LANIER – LD090/LD0105
RICOH – AFICIO 2090/2105
SAVIN – 4090/40105
SUBJECT: ENHANCED FIRMWARE UPDATE REMARKS
IMPORTANT NOTES REGARDING FIRMWARE UPGRADE FOR THE OLDER
B070/B070 TO THE B070/B071 ENHANCED VERSION:
As described in Technical Service Bulletin B070/B071-035; the B070/B071 enhanced version copier is an
updated version of the older B070/B071 model. The B070/B071 enhanced model utilizes the following
updated firmware levels listed in the table below.
This enhanced firmware is the latest and can be uses on all new and older B070/B071 models. Any future
firmware updates on this model will be based on this enhanced firmware.
The B070/B071 Enhanced Firmware is available on the TSC Web Site.
IMPORTANT STEPS:
When updating an older B070/B071 field machine to the current B070/B071 enhanced version firmware, all
of the following firmware levels need to be upgraded as a set.
Use the following procedure to update the firmware to the current B070/B071 Enhanced Version:
1. First, insert the firmware SD Card and update the "System" firmware only.
2. After successfully updating the "System" firmware, turn the machine main power "OFF."
3. Remove the firmware and Printer/Scanner SD Card and confirm that the machine boots up normally to a
Ready Condition (If the Printer/Scanner SD Card is not removed during this step an SC990 will occur).
This SC990 condition will be cleared when the "Printer" firmware is updated in the next step.
4. Re-insert the firmware and the Printer/Scanner SD Card and update the "Printer" firmware only. The
Service Call Indicator LED will illuminate on the operation panel, wait until the "Update Menu" appears
on the operation panel display (approximately 1 minute). This Service Call Indication will not re-occur
after the "Printer" firmware is updated to level V2.07.
5. Update the remaining firmware individually. When updating the "LCDC" firmware.
DO NOT TURN THE MACHINE "OFF" UNTIL THE "LCDC" FIRMWARE UPDATE IS COMPLETE.
If the machine is powered "OFF" before the "LCDC" firmware update is complete, damage to the
operation panel will occur.
Copyright  2004 RICOH Corporation. All rights reserved.
CÓPIA NÃO CONTROLADA
TECHNICAL SERVICE BULLETIN
B070/B071 – 037 REISSUE
CÓPIA NÃO CONTROLADA
06/11/2004
Page 1 of 2