Gestetner B070 Service Manual page 1092

Rev. 05/2004
5.10.8 HANDLING FIRMWARE UPDATE ERRORS
If an error occurs during a download, an error message will be displayed in the first
line. The error code consists of the letter "E" and a number ("E20", for example).
Error Message Table
CODE
Cannot map logical address
20
21 Cannot access memory
Cannot decompress
22
compressed data
Error occurred when ROM
23
update program started
SD card access error
24
No HDD available for stamp
30
data download
Data incorrect for continuous
31
download
Data incorrect after download
32 interrupted
⇒
Incorrect SD card version
33
Module mismatch - Correct
34 module is not on the SD card)
Module mismatch – Module on
35 SD card is not for this machine
Cannot write module – Cause
36 other than E34, E35
Engine module download
40
failed
Operation panel module
42
download failed
Stamp data module download
43
failed
Controller module download
44 failed
⇒
Electronic confirmation check
50 failed
⇒
NOTE: Error codes E32 and E44 are sometimes displayed when several type of
firmware are installed simultaneously. To clear the error codes follow the
procedure described in Clearing E32 and E44 Codes. After clearing the
error code, re-install the firmware.
SM
CÓPIA NÃO CONTROLADA
MEANING
Make sure SD card inserted correctly, or use
another SD card.
HDD connection incorrect or replace hard disks.
Incorrect ROM data on the SD card, or data is
corrupted.
Controller program abnormal. If the second attempt
fails, replace controller board.
Make sure SD card inserted correctly, or use
another SD card.
HDD connection incorrect or replace hard disks.
Insert the SD card with the remaining data required
for the download, the re-start the procedure.
Execute the recovery procedure for the intended
module download, then repeat the installation
procedure. See NOTE below.
Incorrect ROM data on the SD card, or data is
corrupted.
SD update data is incorrect. Acquire the correct
data (Japan, Overseas, OEM, etc.) then install
again.
SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct update
data then install again.
SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct update
data then install again.
Replace the update data for the module on the SD
card and try again, or replace the BCU board.
Replace the update data for the module on the SD
card and try again, or replace the LCDC.
Replace the update data for the module on the SD
card and try again, or replace the hard disks.
Replace the update data for the module on the SD
card and tray again, or replace controller board.
See NOTE below.
SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct update
data then install again.
5-119
CÓPIA NÃO CONTROLADA
FIRMWARE UPDATE
SOLUTION
B070/B071