Gestetner B070 Service Manual page 1224

Tech Service Bulletin No. B070/B071 – 041
LCDC Recovery Procedure
IMPORTANT: If you are updating the machine from a B070/B071 non enhanced to a B070/B071 enhanced,
this recovery procedure will not work. In this case, the LCDC board must be replaced.
•
Reason: The firmware recovery program is overwritten only when you update from the B070/B071
non enhanced to B070/B071 enhanced.
•
See TSB B070/B071 – 037R for details about the B070/B071 firmware.
1. Insert the SD card that contains the LCDC firmware.
2. Turn the main power ON. The operation panel will display the following message:
3. Make sure to wait for the update to begin. This will take about one minute.
CÓPIA NÃO CONTROLADA
Warning
Install failure of operation panel program
Turn machine off
Set SD card of operation panel and turn on
CÓPIA NÃO CONTROLADA
Page 2 of 2