Gestetner B070 Service Manual page 1037

SERVICE PROGRAM MODE TABLES
SP
6119 Punch Function Enabled (Thick Paper)
6120 Staple Jogger Adjustment
001 A3 (Lengthwise)
002 B4 (Lengthwise)
003 A4 (Lengthwise)
004 A4 (Sideways)
005 B5 (Lengthwise)
006 B5 (Sideways)
007 DLT (Lengthwise)
008 LG (Lengthwise)
009 LT SEF (Lengthwise)
010 LT LEF (Sideways)
011 Other
6121 Staple Jogging Repeat Setting
6902 Fold Position Adjustment
B070/B071
CÓPIA NÃO CONTROLADA
Number/Name
CÓPIA NÃO CONTROLADA
Function/[Setting]
Determines whether punch mode is
enabled in thick paper mode.
[0~1 / 0 / 1]
0: Disabled
1: Enabled
Adjusts the staple jogger positions for
each paper size. The higher the setting,
the narrower the jogger span.
[-1.5~+1.5 / 0 / 0.5 mm]
Firmware requirements
The following firmware combinations are
required to activate the SP modes:
•
BCU (B0705254A) 4.01.1 or later
•
GW (B0705754A) 3.04.1 or later
•
EP- ROM (B4685132 or later)
Determines whether jogging is executed
once or twice for each sheet.
[1~2 / 1 / 1]
1: Once
2: Twice
This SP applies to the B478 finisher only.
Use the 10-key pad to adjust the staple
position in center folding.
[-3.5~+3.5 / 0 / 0.5 mm]
•
Use the " /*" key to toggle between + and
–.
A larger value decreases the length of
trailing edges, a smaller value increases
the length of trailing edges.
5-54
Rev. 11/2003
⇐
SM