Vtp Domain - Cisco Catalyst 4500 Series Command Reference Manual

vtp domain

vtp domain
To configure the administrative domain name for a device, use the vtp domain command.
Syntax Description
domain-name
Defaults This command has no default settings.
Command Modes VLAN configuration mode
Command History Release
12.1(8a)EW
Usage Guidelines When you define the domain-name, the domain name is case sensitive and can be from 1 to 32 characters.
You must set a domain name before you can transmit any VTP advertisements.
Even if you do not set a domain name, the device will leave the no-management-domain state upon
receiving the first VTP summary packet on any port that is currently trunking.
If the device receives its domain from a summary packet, it resets its configuration revision number to
zero. Once the device leaves the no-management-domain state, it can never be configured to reenter the
number except by cleaning NVRAM and reloading.
Examples
This example shows how to set the devices administrative domain:
Switch(vlan-config)# vtp domain DomainChandon
Switch(vlan-config)#
Related Commands Command
show vtp
vtp (global configuration
mode)
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
2-1078
vtp domain domain-name
Name of the domain.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Displays VTP statistics and domain information.
Configures the name of a VTP configuration storage file.
OL-25342 -01