Revision (Mst) - Cisco Sx350 Cli Manual

Spanning-Tree Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Default Configuration
The default name is the bridge MAC address.
Command Mode
MST Configuration mode
Example
The following example defines the instance name as Region1.
switchxxxxxx(config)#
switchxxxxxx(config-mst)#

58.25 revision (MST)

Use the revision MST Configuration mode command to define the MST
configuration revision number. Use the no form of this command to restore the
default configuration.
Syntax
value
revision
no revision
Parameters
value—Specifies the MST configuration revision number. (Range: 0–65535)
Default Configuration
The default configuration revision number is 0.
Command Mode
MST Configuration mode
Example
The following example sets the configuration revision to 1.
spanning-tree mst configuration
region1
name
58
1122