Installing The Chassis; Installing The Chassis On A Flat Surface; Figure 2 Placement Of Rubber Feet On The Bottom Of The Chassis - Nortel Contivity 1740 Installing

Installing the chassis

To install the Contivity 1740, do one of the following:
• Position the chassis on a flat, sturdy, horizontal surface.
• Mount the chassis in a standard equipment rack (see
an equipment rack" on page

Installing the chassis on a flat surface

If you decide to place the Contivity 1740 on a flat surface, make sure that the
surface is large enough for the gateway and sturdy enough to support the
combined weight of the Contivity 1740 and the cables that you attach to it.
The Contivity 1740 accessory kit includes four rubber feet that can be attached to
the bottom of the gateway.

Figure 2 Placement of rubber feet on the bottom of the chassis

Chapter 1 Installing the Contivity 1740 chassis 23
24).
Figure 2 shows the placement of these rubber feet.
Attach feet (4)
CS160016A
"Installing the chassis in
Installing the Contivity 1740