Programming The System Settings - Nortel Meridian Companion Installation And Maintenance Manual

Programming the system settings

P0725810 Issue 3.0
digits. You will find it easier to remember the password if the
numbers correspond to a word.
!
You should change the Registration password after the system is
installed to protect the integrity of the settings.
To prevent unauthorized access, provide the Registration password
only to selected personnel.
To change the Registration password, follow these steps:
1. Enter Administration programming.
2. Press * or & until the display shows
6. Passwords.
3. Press ^. The display shows Admin. password.
4. Press *. The display shows Reg. password.
5. Press CHANGE. The display shows New pswd: _.
6. Enter a new one- to six-digit Registration password. Use BKSP to
correct your entry if required. Press OK. The display shows Re-
enter: _.
Note: If you do not enter any digits and press OK, the display
shows Pswd not changed.
7. Re-enter the digits and press OK. The display should show
Password changed. If the display shows Pswd not changed,
you did not enter the same password again. Go back to step 5.
8. Record the new Registration password in the COMPANION 200
Programming Record.
To properly set up the system, you must change or program the
following settings:
• Set the system time and date
• Set the dial mode of an access line
• Set the Link time
• Set the host switch delay
• Set the gain pad
There are also two optional system settings you can change if
needed:
COMPANION 200 Installation and Maintenance Guide
Programming the COMPANION 200 92