Install The New 1005R Server (Cp2) - Nortel CallPilot Install Manual

Feature Expansion: Adding the High Availability feature to an existing CallPilot 5.0 1005r server 261
2
3

Install the new 1005r server (CP2)

A second 1005r server is required to complete the High Availability pair.
The following procedure assumes that this 1005r server has come from the
factory with CallPilot 5.0 and the High Availability feature installed.
Installing the new 1005r server (CP2)
Step
1
2
3
4
5
Copyright © 2007, Nortel Networks
.
Prepare the switch by adding additional MGate cards as required.
Program the switch as necessary.
Action
Refer to the following documents to perform the steps outlined in
this procedure.
• 1005r Server Hardware Installation (NN44200-308).
• Installation and Configuration Task List (NN44200-306)
Unpack the server.
Install CP2 in the same rack as CP1.
Ensure that the two servers are close enough so that they can be
connected by the crossover LAN cables for the HB1, HB2, and
MIRROR connections. The cables must be long enough to connect
the two 1005r servers.
Do not connect the HB1, HB2, and MIRROR crossover LAN cables at
this time.
Connect the peripheral equipment to both servers.
The peripheral equipment includes the monitor, keyboard, and
mouse.
Power on the CP2 server.
Result: The server starts and the Windows 2003 Mini-Setup runs.
During the Windows 2003 Mini-Setup, the server automatically
restarts twice.
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
—End—
ATTENTION
—End—