Nortel CallPilot Install Manual page 155

5
6
7
8
Copyright © 2007, Nortel Networks
.
c. Select the CallPilot Individual Feature Configuration
(Express Mode) option and then click Next.
Result: The Configuration Wizard: Express Configuration List
screen appears.
d. Select the Network Interface Card Configuration (ELAN and
CLAN) check box.
e. Change the IP addresses as required.
f. Click Next.
Result: The Ready to Configure screen appears.
g. Click Finish.
Result: A dialog box prompts you to confirm the configuration.
h. Click OK to configure CallPilot.
Result: The configuration is applied to the server. This task can
take from 5 to 10 minutes to complete. The Configuration Wizard
displays progress information.
After the configuration is applied to the server, a dialog box
reminds you to restart the server for the configuration to take
effect.
i. Click OK to dismiss the dialog box.
Result: The system returns you to the main CallPilot Manager
screen.
j. Log off CallPilot Manager and close the Web browser.
Restart the server.
Repeat the previous steps if the same IP change is required on the
other High Availability server.
Connect the LAN.
For more information, see
(page 68) and complete the following procedures:
• "Connecting and verifying LAN connections" (page 69)
•
"Modifying the hosts file" (page 72)
• "Testing the host name resolution" (page 74)
Check the configuration of CP1 and CP2.
For more information, see
Configuration Wizard to check CP1 and CP2 configuration" (page
75).
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
CallPilot Configuration Wizard 155
"Connect and verify LAN connections"
(optional)
"Running Stage 1 of the High Availability