Nortel CallPilot Install Manual page 66

66 Chapter 5 Install and configure the High Availability pair
20
21
22
23
24
Copyright © 2007, Nortel Networks
.
iii. Ensure that Channel Allocation is set to Multimedia.
iv. Click OK.
Result: The Meridian 1 Switch Information window appears
again.
v. Continue the provisioning of channels until complete.
Note: To automatically provision a number of channels, you
can enter the information for one channel, select the number
of channels required, and then click Fill. The Configuration
Wizard automatically datafills the channels, and increments
the TNs, ACD Position ID, and SCN.
The number of TNs configured on CP2 must be the same as
the number configured on CP1.
Note: This is the CP2 switch-provisioning information for the
switch. To obtain the CP2 switch-provisioning information, see
the completed Table 3 "High Availability system checklist" (page
25).
Click Next.
Result: The Meridian 1 CDN Information page appears.
Click New to add a new CDN.
Result: The CDN Details page appears.
On the CDN Details page, do the following:
a. In the CDN field, enter the new CDN.
Note: The CDN for CP2 must be the same as the CDN
configured on CP1.
b. Select the Application Name (Voice Messaging or Multimedia
Messaging).
c. Click OK.
Result: The new CDN is added and the CDN information page
reappears.
Click Next.
Result: The Language Source Directory page appears.
Insert the CallPilot 5.0 Language CD in to the CD/DVD drive on CP2.
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007