Page 240 of 284
First boot of a new Nortel CP PM Signaling Server
Before you begin
NN43021-469 Standard 01.01 May 2007
Installing a Signaling Server
19 Remove the Signaling Server Software CD or the Signaling Server
Software CF Card (as appropriate) from the RMD drive of the Signaling
Server and enter q to close/terminate the Installation Tool and reboot the
system. The following system messages appear:
Removing temporary file "/u/disk.sys".
Rebooting system ....
Nortel CP PM Signaling Servers have CS 1000 Release 5.0 software,
applications, operating system, and web files preloaded on the hard drive
when they are shipped. On the first boot of a Nortel CP PM Signaling Server,
the Signaling Server Software Installation Tool prompts you to enter basic
system configuration parameters.
Before booting the new Nortel CP PM Signaling Server for the first time and
entering basic system configuration parameters, you must perform the
following tasks:
•
Install and connect the Signaling Server (refer to "Installing the CP PM
Signaling Server hardware" on
•
Obtain the network and IP Telephony data for the Signaling Server from
your Planning and Engineering group:
–
node ID for the IP Telephony node
–
node IP address for the IP Telephony node
–
hostname for the Signaling Server
–
ELAN network interface IP address, Subnet mask, and
Gateway
–
TLAN network interface IP address, Subnet mask, and
Gateway
–
ELAN network interface IP address of the Call Server
End of Procedure
page
179).