Run Stage 1 Of The High Availability Configuration Wizard To Check Cp1 And Cp2; Configuration - Nortel CallPilot Install Manual

Run Stage 1 of the High Availability Configuration Wizard to check CP1 and CP2 configuration
2
Run Stage 1 of the High Availability Configuration Wizard to check
CP1 and CP2 configuration
The High Availability Configuration Wizard is run twice during the
configuration of a High Availability server pair:
•
•
Running Stage 1 of the High Availability Configuration Wizard to check
CP1 and CP2 configuration
Step
The High Availability Configuration Wizard is only run on CP1.
1
2
Copyright © 2007, Nortel Networks
.
Result: If the CLAN is properly connected and the host file is
configured with the IP address and host name information, a
reply is displayed showing the Managed CLAN IP address and
the time to return.
d. Repeat (if necessary) with other host names from CP2.
On CP2, repeat the preceding steps.
Stage 1: The High Availability Configuration Wizard is run for the first
time to gather and verify the configuration of the two nodes in the High
Availability pair. This is done to ensure that the nodes are correctly
configured (for example, to ensure that the networking information is
consistent between the two nodes). For more information, see
Stage 1 of the High Availability Configuration Wizard to check CP1 and
CP2 configuration" (page
Stage 2: The High Availability Configuration Wizard is run a second
time to verify the AutoStart software installation and to generate the
definition file that is imported into the AutoStart Console to provide the
initial configuration. For more information, see
Definition File" (page
Action
Use Windows Explorer to navigate to the D:\Nortel\HA folder.
Double-click the HighAvailabilityConfigurationWizard.exe file.
Result: The High Availability Configuration Wizard appears.
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
—End—
75).
115).
"Running
"Generating the AutoStart
75