Nortel CallPilot Install Manual page 251

14
15
16
17
Copyright © 2007, Nortel Networks
.
Figure 154
Delete Current Data Source
On CP1, use the AutoStart Console to select the first node (expand
[AutoStart_Domain] > Nodes > CP1) and do the following:
a. Select the Failure Detection and Mirroring tab.
b. Under Configure Mirror Settings, change the Remote Mirror
Host value to None.
c. Click Apply.
On CP1, use the AutoStart Console to select the second node
(expand [AutoStart_Domain] > Nodes > CP2) and do the following:
a. Select the Failure Detection and Mirroring tab.
b. Under Configure Mirror Settings, change the Remote Mirror
Host value to None
c. Click Apply.
Restart both servers.
On CP1, use the AutoStart Console to select the first node (expand
[AutoStart_Domain] > Nodes > CP1) and do the following:
a. Select the Failure Detection and Mirroring tab.
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
Support 251