Nortel CallPilot Install Manual page 160

160 Chapter 6 Maintaining a High Availability system
7
8
9
Changing the Managed ELAN IP address
Step
This procedure changes only the Managed ELAN IP address. (It does not
change the physical ELAN IP settings.)
1
2
Copyright © 2007, Nortel Networks
.
On the AutoStart Console, add the new Managed CLAN IP resource
into the Startup and Shutdown sequences of the CallPilot resource
group. Using the arrows, move the Managed CLAN IP back to its
original location, which is:
• directly after the Managed ELAN IP in the Startup Sequence list
• directly before the Managed ELAN IP in the Shutdown Sequence
list
a. Expand [AutoStart_Domain] > Resource Groups > CallPilot.
b. Select the Settings tab.
c. Under the Startup Sequence, select the new Managed CLAN IP
address and click Edit.
d. Clear the Failure Response Settings check boxes.
e. Click Apply.
f. Under the Startup Sequence, select the new Managed CLAN
IP address and move it directly below the Managed ELAN IP
address.
g. Under the Shutdown Sequence, select the new Managed CLAN
IP address and move it directly above the Managed ELAN IP
address.
h. Click Apply.
Bring the CallPilot resource group online. For more information, see
"Bringing the CallPilot resource group online" (page
Enable the AutoStart Monitoring. For more information, see
"Enabling automatic failovers (start monitoring)" (page
Action
Disable the AutoStart Monitoring. For more information, see
"Disabling automatic failovers (stop monitoring)" (page
Take the CallPilot resource group offline. For more information, see
"Taking the CallPilot resource group offline" (page
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
—End—
209).
214).
213).
211).