Configure Cp1 Using The Configuration Wizard - Nortel CallPilot Install Manual

Feature Expansion: Adding the High Availability feature to an existing CallPilot 5.0 1005r server 271
12
13
14
Configure CP1 using the Configuration Wizard
Configuring CP1 using the Configuration Wizard
Step
1
Copyright © 2007, Nortel Networks
.
Result: The database upgrade starts and the Upgrading Data
screen appears.
IF the database
upgrade is
not successful
successful
Click Next to complete the Setup Wizard.
Result: The Finished screen appears.
Read the information displayed on the Finished screen and click
Finish.
Result: A screen appears warning you that the system restarts
automatically.
Click OK.
Result: The system restarts.
Action
On the existing CallPilot 1005r server (CP1), log on to CallPilot
Manager:
a. After the Windows log on screen appears, log on with the current
password.
b. Launch Internet Explorer.
c. Enter http://<server name or IP address>/cpmgr in the URL
address box.
Result: The CallPilot Manager Logon Web page appears.
d. Log on using your existing CallPilot logon information. Enter
information into the following:
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
THEN
• click Upgrade Database to try again.
Note: If subsequent attempts to upgrade the
database are not successful, contact your support
organization.
• the Setup Wizard continues.
—End—