Software Operations - Nortel CallPilot Install Manual

216 Chapter 6 Maintaining a High Availability system
5

Software operations

Use the following procedures to install, uninstall, and reinstall the EMC
AutoStart software.
•
•
•
•
Install the AutoStart Console on a stand-alone PC
The AutoStart Console is used to administer the AutoStart Agent that
provides the mirroring and heartbeat signals between the active and standby
CallPilot servers. The AutoStart Console also provides the managed
(virtual) IP service that is used on the CLAN and ELAN to mask the fact
that there are two different servers.
By default, the AutoStart Console software is installed on both CallPilot
servers. However, it is possible to install the AutoStart Console software
on a stand-alone PC.
After the AutoStart Console is installed on a stand-alone PC, it can be
used to manage multiple pairs of CallPilot High Availability servers (that
is, multiple AutoStart domains). Use the following procedure to install the
AutoStart Console software on a stand-alone PC for administration of the
Nortel server subnet (CLAN).
Copyright © 2007, Nortel Networks
.
Result: The Confirm Relocated of Resource Group dialog box
appears.
Figure 125
Confirm Relocate of Resource Group
Click Yes.
Result: The failover starts in seconds. It takes more than 10 minutes
to finish the failover to the standby server if the CallPilot Diagnostic
Tools are enabled, or less than 5 minutes if the CallPilot Diagnostic
Tools are disabled. (Start > Programs > CallPilot > System Utilities
> Diagnostic Tools)
"Install the AutoStart Console on a stand-alone PC" (page 216)
"Uninstall the AutoStart software" (page 228)
"Reinstall the AutoStart software" (page 234)
"EMC software updates (AutoStart Agent/Console)" (page 235)
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
—End—