Prepare The Switch And Install The 1005R Servers - Nortel CallPilot Install Manual

40 Chapter 5 Install and configure the High Availability pair
Task
Test your configuration
Create the CallPilot
Reporter connections
Add server to a Windows
domain (if required)

Prepare the switch and install the 1005r servers

Before you install and configure the High Availability feature you must
prepare the switch and 1005r servers. Use the following procedures to
prepare the switch and install the 1005r servers.
Preparing the switch
Step
1
Installing the two 1005r servers
Step
1
Copyright © 2007, Nortel Networks
.
Estimated time
120 minutes
20 minutes
30 minutes
Action
Configure the Meridian 1 or CS 1000 switch by referring to the
following documents:
• Meridian 1 and CallPilot Server Configuration (NN44200-302)
• Communication Server 1000 and CallPilot Server Configuration
(NN44200-312)
Note: Both High Availability servers must use the same Control
Directory Number (CDN). The MGate cards on the switch must
provide twice the channel capacity than that of a single High
Availability server. However, only half the channels are in use at
any one time (the other half of the channels are in standby mode).
Action
Refer to 1005r Server Hardware Installation (NN44200-308) and
Installation and Configuration Task List (NN44200-306) for details
about performing the following tasks:
a. Unpack both of the CP1 and CP2 servers.
b. Install the dongle on CP1.
c. Connect the peripheral equipment (monitor, keyboard, and
mouse) to both servers.
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
Procedures required to complete the task
– "Testing the configuration of CP1 and CP2"
(page 127)
– "Creating the CallPilot Reporter connection"
(page 129)
– "Joining a Windows domain" (page 130)
—End—