Nortel CallPilot Install Manual page 112

112 Chapter 5 Install and configure the High Availability pair
4
Adding the Remote Mirroring Host for CP2
Step
1
2
3
Copyright © 2007, Nortel Networks
.
d. In the Usage drop-down list, select Verification.
e. In the Local IP Address drop-down list, select the ELAN IP
address for CP2.
f. Click Add Path.
g. In the Paths Defined for Node list, select the entry that has
the CLAN IP address for CP2.
h. Click Delete Path.
i. In the Usage drop-down list, select Verification.
j. In the Local IP Address drop-down list, select the CLAN IP
address for CP2.
k. Click Add Path.
l. Click Apply.
m. Click Yes, if you are prompted to restart the agent to apply the
changes.
Note: It takes a few minutes for the agent to restart.
Wait for the CP1 node and the CP2 node to start.
The icon for the nodes (in the left-hand pane of the AutoStart
console) turn green after the AutoStart Agent starts.
Action
On CP1, and in the Domains pane, select the CP2 node (Domains
> [AutoStart_Domain] > Nodes > <CP2 Node Name>).
Select the Failure Detection and Mirroring tab.
Ensure that the value in the Local Mirror Address field is set to
the IP address assigned to the MIRROR NIC on CP2. (The default
value is 193.0.0.11.)
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
—End—