Nortel CallPilot Install Manual page 274

274 Chapter 7 Upgrades, migrations, and feature expansion
16
17
18
19
20
21
Copyright © 2007, Nortel Networks
.
Result: The system returns you to the CDN Information page.
Click Next.
Result: The Language Source Directory screen appears.
Select the Skip Language CD Validation option.
Click Next.
Result: The CallPilot Local Area Network Interface screen appears.
On the CallPilot Local Area Network Interface screen, do the
following:
a. Make note of the current ELAN and CLAN IP addresses.
Note: These ELAN and CLAN IP address values from the
existing CallPilot 1005r server (CP1) will be reused as the
Managed ELAN/CLAN IP address for the pair of server in the
new High Availability configuration.
b. Change the ELAN and CLAN IP address values to the new
values.
c. Select the High Availability mode check box.
Note: To enable High Availability, a proper keycode is
required and the High Availability Mode check box must be
selected.
d. Enter IP information for the HB1, HB2, and MIRROR network
interface cards.
The following table shows the suggested default values for HB1,
HB2, and MIRROR on CP1. If you do not use these suggested
values, ensure that you use your new values throughout the
configuration.
Network Interface Card
(NIC)
Heartbeat 1 (HB1)
Heartbeat 2 (HB2)
MIRROR
Click Next.
Result: The Ready to Configure screen appears.
Click Finish.
Result: A dialog box prompts you to confirm the configuration.
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
IP Address Subnet Mask
192.0.0.10 255.255.255.0
194.0.0.10 255.255.255.0
193.0.0.10 255.255.255.0