Nortel CallPilot Install Manual page 111

3
Copyright © 2007, Nortel Networks
.
g. In the Paths Defined for Node list, select the entry that has
the CLAN IP address for CP1.
h. Click Delete Path.
i. In the Usage drop-down list, select Verification.
j. In the Local IP Address drop-down list, select the CLAN IP
address for CP1.
k. Click Add Path.
Figure 75
AutoStart Console - Failure Detection and Mirroring tab - Adding
path
l. Click Apply.
m. Click Yes, if you are prompted to restart the agent to apply the
changes.
Note: It takes a few minutes for the agent to restart.
In the Domains pane, select the CP2 node (Domains >
[AutoStart_Domain] > Nodes > <CP2 Node Name>).
a. Select the Failure Detection and Mirroring tab.
b. In the Paths Defined for Node list, select the entry that has
the ELAN IP address for CP2.
c. Click Delete Path.
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
Configure the AutoStart software 111