Add The Node 2 Administrator Account To The Autostart Console On Node - Nortel CallPilot Install Manual

92 Chapter 5 Install and configure the High Availability pair
27
28
29
Add the node 2 administrator account to the AutoStart Console on
node 1
Add the node 2 administrator account to the AutoStart Console
on node 1
Step
This procedure adds the CP2 Administrator Account to the AutoStart
Console on CP1.
The CP2 Administrator Account must be added to the AutoStart Console on
CP1 before you install the AutoStart software on CP2. If you try to install the
AutoStart software on CP2 before you add the administrator account of CP2
into the AutoStart console on CP1, the AutoStart Agent installed on CP2 cannot
communicate with the Agent installed on CP1. You must uninstall the Agent and
Console software and then reinstall the software.
1
Copyright © 2007, Nortel Networks
.
Clear the Check for program updates now check box.
Click Finish.
Result: The EMC AutoStart 5.2.2 dialog box appears, prompting
you to restart your system.
Figure 51
EMC AutoStart 5.2.2 dialog box
Click No if there are patches to install or click Yes to restart CP1.
Note: If there are patches available, install the patches and
then restart CP1.
Action
Log on to CP1.
Note: An error can appear, indicating that "At least one service
or driver failed to start." This is normal, as the AutoStart mirroring
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
—End—
ATTENTION