Nortel CallPilot Install Manual page 140

140 Chapter 6 Maintaining a High Availability system
10
11
12
13
14
15
Administrator account changes
Use the following procedure to change the administrator password of a High
Availability system using the Configuration Wizard.
Changing the administrator password of High Availability system
using the Configuration Wizard
Step
1
2
Copyright © 2007, Nortel Networks
.
Rejoin the domain.
Restart the server.
After the server restarts, log on using the CallPilot High Availability
server domain account.
Uninstall, reinstall, and reconfigure the AutoStart software. For more
information, see the following:
• "Uninstall the AutoStart software" (page 228)
• "Reinstall the AutoStart software" (page 234)
•
"Configure the AutoStart software" (page 109)
Bring the Resource group online. For more information, see
"Bringing the CallPilot resource group online" (page
Reenable the AutoStart monitoring after all CallPilot services are
up. For more information, see
monitoring)" (page 214).
Action
If the High Availability system is currently on a workgroup, proceed
to the next step. Otherwise, move the CallPilot 5.0 High Availability
pair from the domain to a workgroup. For more information, see
"Joining a workgroup" (page
On CP1 (the active High Availability server) do the following:
a. Ensure the dongle is plugged into CP1. If the dongle is not on
CP1, move it to CP1 and wait for 3 minutes.
For more information about the dongle, see 1005r Server
Hardware Installation (NN44200-308).
b. Launch the AutoStart Console.
Nortel CallPilot
High Availability: Installation and Configuration
NN44200-311 01.06 Standard
5.0 15 May 2007
"Enabling automatic failovers (start
—End—
176).
209).